User Manual

3. EEG/PSG MEASUREMENT
Operator's Manual WEE-1000 3.3
WARNING
• Do not connect the Z electrode lead plug on the electrode junction
box to a ground or equipotential ground. Otherwise, leakage current
from another instrument cause electrical shock to the patient.
• Only connect a BF type instrument to the DC connector on the
telemetry unit. Otherwise, leakage current from the other instrument
causes electrical shock to the patient.
• Before disconnecting or connecting the cable from/to a connecter on
the telemetry unit, while the telemetry unit is turned on, discharge
electrostatic charge from your body. Otherwise, the telemetry unit
may malfunction due to electrostatic energy.
• When connecting the electrode junction box cable to the electrode
junction box, align the marks on the electrode junction box cable
connector and electrode junction box. Otherwise, leakage current
may cause electrical shock to the patient.
CAUTION
Using a collodion electrode or EEG paste
• If rash, redness or itch appears on the patient skin from the use of
collodion or EEG paste, immediately remove the collodion or EEG
paste from the skin and perform medical treatment.
• Never allow collodion or acetone to get in the patient’s eyes. If
collodion or acetone accidentally gets in the eyes, immediately and
thoroughly wash eyes with clean water and perform medical
treatment immediately.
• If chemical solution is swallowed, have the person drink water and
vomit the chemical solution. Perform medical treatment immediately.
• Collodion is a volatile solvent. Both patients and medical staff must
take extreme care not to inhale collodion. When using collodion,
make sure there is adequate ventilation. If too much collodion is
inhaled, have the person lie quietly and keep warm in fresh air.
Perform medical treatment immediately.
Electrode Attachment/Cable Connection