User's Manual

38 Operator’s Manual ZM-520PA/521PA/530PA/531PA
Connecting the Electrode Lead to the Transmitter
Connect the electrode lead to the ECG/RESP socket on the transmitter.
WARNING
After attaching the electrode to the patient and connecting the electrode lead to the
transmitter, check that electrodes are attached to the patient and check that the
electrode lead is connected to the transmitter properly. When the electrodes are
removed from the patient, do not touch the metal part of the electrode with bare
hands or let the metal part of the electrode contact the metal part of the bed or any
other conductive parts. Failure to follow this warning may cause electrical shock or
injury to the patient by discharged energy.
CAUTION
Do not shake or swing the transmitter while holding the leads or cables connected to
the transmitter. The transmitter may come off and injure someone or damage
surrounding instruments.
CAUTION
Hold the connector of the electrode lead when connecting/disconnecting the
electrode lead. If you disconnect the electrode lead by pulling the lead, it damages
the electrode lead.

૞ᚑ㒙ጊޓᖘᏆ ᛚ⹺⌀ᨩޓ⌬