User's Manual

44 Operator’s Manual ZM-520PA/521PA/530PA/531PA
Refer to the electrode operator’s manual for details.
1. Carefully remove the backing paper from the
electrode. Avoid touching the adhesive surface.
2. Place the electrode on the previously cleaned skin. Pay
attention to the electrode lead color and symbol.
3. Clip the electrode lead to the electrode.
4. Fasten the electrode lead wire with surgical tape
with an extra length of wire between the tape and the
electrode. This lessens the movement of electrode
leads by body movement and helps stable monitoring.
Checking ECG on the Transmitter Screen
After attaching electrodes and connecting ECG leads, check that the electrodes are properly
attached to the patient and the ECG waveform is acquired on the check electrodes screen. For
details on the screen, refer to the “Screen Descriptions” section.
Attaching the SpO
2
Probe
Selecting the SpO
2
Probe
Select an appropriate probe for the patient.
CAUTION
Only use Nihon Kohden specified
electrodes, electrode leads and SpO
2
probes. Otherwise, the maximum
performance from the transmitter
cannot be guaranteed.
CAUTION
Do not use a damaged or
disassembled probe. It causes
incorrect measurement and may injure
the patient.

૞ᚑ㒙ጊޓᖘᏆ ᛚ⹺⌀ᨩޓ⌬