User's Manual

32 Operator’s Manual ZM-520PA/521PA/530PA/531PA
Changing System Setup Settings
PROTOCOL
Select the transmitting protocol. For differences between protocols, refer to the table below.
 1HZSURWRFRO$FHQWUDOPRQLWRUZLWKDQ25*$RU25*$PXOWLSOHSDWLHQW
UHFHLYHUZKRVHVRIWZDUHYHUVLRQRUODWHUFDQUHFHLYHWKLVSURWRFRO
 2OGSURWRFRO$FHQWUDOPRQLWRUZLWKDQ25*$25*$RU25*$PXOWLSOH
patient receiver can receive this protocol.
NOTE
When 51 is set, the receiving monitor must be able to receive protocol 51. Otherwise,
signals from the transmitter cannot be received.
Differences Between Protocols
Function Protocol 41 Protocol 51
6HWWLQJ(&*0($685(0(17WR2))RQ
the transmitter automatically turns off the
(&*PHDVXUHPHQWVHWWLQJRQWKHUHFHLYLQJ
monitor
1R(&*PHDVXUHPHQW
must be turned off on
the receiving monitor)
Yes
Pause monitoring on the receiving monitor
from the transmitter
No Yes
7UDQVPLW³3$7,(17&21),50('´PHVVDJH No Yes
Display battery level of the transmitter on the
receiving monitor
No Yes
Transmit SpO
2
messages
Some messages (refer
to the “Indication and
Message List” section)
All messages
7UDQVPLW5(63PHVVDJH No Yes
 3UHVVWKHŹNH\WRPRYHWKHFXUVRUWR
“PROTOCOL”.
 3UHVVWKH)XQFWLRQNH\
 3UHVVWKHŹNH\WRVHOHFW³´RU³´
Setting
Cursor