User's Manual

66 Operator’s Manual ZM-920PA/921PA/930PA/931PA
Electromagnetic Compatibility
IEC 60601-1-2: 2001
IEC 60601-1-2 Amendment 1: 2004
Electromagnetic Emissions
This Model ZM-921PA/931PA is intended for use in the electromagnetic
environmentspeciedbelow.ThecustomerortheuseroftheZM-921PA/931PA
should assure that it is used in such an environment.
Emissions test Compliance Electromagnetic environment guidance
RF emissions
CISPR 111
Group 1roup 1oup 1 The ZM-921PA/931PA uses RF energy onlyZM-921PA/931PA uses RF energy only uses RF energy only
for its internal function. Therefore, its RF internal function. Therefore, its RFinternal function. Therefore, its RF Therefore, its RFTherefore, its RF
emissions are very low and are not likely to low and are not likely tolow and are not likely to and are not likely toand are not likely to
cause any interference in nearby electronicnterference in nearby electronicterference in nearby electronicference in nearby electronicerence in nearby electronicn nearby electronic nearby electronicroniconic
equipment..
RF emissions
CISPR 11111
Class Blass B The ZM-921PA/931PA is suitable for usee ZM-921PA/931PA is suitable for use ZM-921PA/931PA is suitable for useZM-921PA/931PA is suitable for use is suitable for usele for usee for use
in all establishments, including domesticll establishments, including domesticl establishments, including domestic establishments, including domesticestablishments, including domesticts, including domestics, including domestic including domesticincluding domestic
establishments.
Harmonic emissions
IEC 61000-3-2000-3-20-3-22
Not
applicable
Voltageuctuations/
ickeremissions
IEC 61000-3-3
Not
applicable
Electromagnetic Immunity
This Model ZM-921PA/931PA is intended for use in the electromagnetic
environmentspeciedbelow.ThecustomerortheuseroftheZM-921PA/931PA
should assure that it is used in such an environment.
Immunity test
IEC 60601 test
level
Compliance
level
Electromagnetic
environment -
guidance
Electrostatic
discharge (ESD)
IEC 61000-4-2
±6 kV contact
±8 kV air
±6 kV contact
±8 kV air
Floors should be wood,
concrete or ceramic tile.
Ifoorsarecovered
with synthetic material,
the relative humidity
should be at least 30%.