KMNA-060009 NM0-010605
RECHARGING "WARNING! USE UNDER THE DIRECT SUPERVISION OF AN ADULT." The newly purchased Ni-Cd pack is not charged. Charge before operating. Charger’s connector Battery’s Connector 1. Join the connector of the charger to the connector of the Ni-Cd battery pack. 2. Plug the charger into an electrical outlet. 3. Recharge for about 4-5 hours. 4. When the recharging is over, plug out the charger from the electrical outlet and detach the connectors.
PREPARATION FOR STARTING OPERATION 1. ATTACHING ANTENNA TUBE Antenna wire Pass the antenna wire through the antenna tube, then insert the tube into the antenna tube holder. If the antenna tube cannot be successfully inserted into the antenna tube holder, try holding the root of the antenna wire with fingers of one hand and extending the wire with fingers of the other hand. Antenna tube Antenna tube holder * Note: Be careful not to pull antenna wire too strong. 2.
ON OFF 4
USING THE CONTROLLER OFF (1) Extend transmitter antenna to its full length. The vehicle can be controlled from a long distance by holding the transmitter higher with the antenna straight up. ON (2) Turn on the transmitter (3) Turn “ON” the vehicle. by operating the control stick. (The power indicator will light up.) Steering control stick Forward / Reverse control stick FORWARD LEFT / STRAIGHT / RIGHT STOP (NEUTRAL) Red LED power indicator REVERSE (4) Start operating the vehicle.
TO ADJUST STEERING ALIGNMENT Adjust the steering alignment when the vehicle does not run straight forward. Turn the steering alignment lever towards “L” if the vehicle runs towards right. L Turn the steering alignment lever towards “R” if the vehicle runs towards left.