Operation Manual

10-16x

1. Remove the nameplate and carefully loosen the connector for the nameplate lighting (fig. 1).

2. Mount the external unit on the wall.

The recommended installation height for the ca-

mera is 160 to 170 cm from the ground. Run the

cable from the bottom up in the device in order to

avoid water entering the device via the cable.

3. Connect the wiring as shown in the wiring

diagram on 28.

Note: In a single system, use the same colour code

for the same terminals (a, b, P, M, V1, V2) for all

products of the Niko Access Control range.

4. You can fill out the provided blank namecard

and add it to the nameplate. Carefully open the

nameplate with a small screwdriver or with the key

provided (fig. 2).

5. Reinsert the nameplate into the external

unit.

3.2. Connecting an extra door opener relay

You can optionally connect a door opener relay

to the external unit between terminals R and P.

This relay is necessary:

• if several external units are used.

• if the external unit is to be provided with a

local door opener contact.

3.3. Six-wire/five-wire cabling

In systems of a limited size, you can choose five-wire cabling. In this case, you do not need to connect a

cable to the M-terminal. You should set up all the jumpers on the five-wire cabling configuration.

fig. 1

fig. 2