Operation Manual

31
10-16x
EN
7. TECHNICAL DATA
Dimensions: .......................175 x 104 x 16 (19) mm (HxWxD)
Ambient temperature:.........-20 – 50°C
Housing material: ...............aluminium/acryl glass
Power consumption: ........... active I(P) = 180 mA – passive I(P) = 125 mA – I(a) = 0.4 mA
Power supply voltage: .........24 Vdc ± 8%
Camera: ............................. CCD sensor 420 lines
light sensitivity: 0.2 lux
focal distance: 3.7 mm
diagonal opening angle: 90°
video output: 1 Vpp, symmetrical
8. WARNINGS REGARDING INSTALLATION
- The installation should be carried out by a registered installer and in compliance with the statutory
regulations.
- This user manual should be presented to the user. It should be included in the electrical installation file,
and it should be passed on to any new owners. Additional copies are available on the Niko website or via
the Niko support service.
- During installation, the following should be taken into account (non-exhaustive list):
- the statutory laws, standards and regulations.
- the technology currently available at the time of installation.
- this user manual, which only states general regulations and should therefore be read within the scope
of each specific installation.
- the rules of proper workmanship.
- In case of doubt or for the specific exchange procedure in case of a possible defect, contact the Niko
support service (Belgium: [phone] – United Kingdom: [phone]) or your wholesaler.
Contact details and more information can be found at www.niko.eu under the “Help and advice” section.
Problem Cause Solution
Negative tone when pressing the
bell push button.
Programming error or
associated internal unit not
correctly installed.
Erase programming, then restart
programming.
Installation in programming
mode.
Quit programming mode.
Speech and other functions (e.g.
door opener) are working, but
there is no image.
The internal or external unit
receives no power.
Check cabling on the power
supply, internal unit and external
unit using the wiring diagram.
The image is completely
disturbed and unrecognisable
(striping, …).
V1 and V2 are reversed. Reverse the conductors.