User's Manual

Trimble TS635 Construction Total Station User Guide 63
Applications 4
When a distance measurement is taken, the
difference between the measured point and the
design point appears.
7. To record the point as an SO record, press
[ENT].
Note – Press
[DSP] to switch between display screens. See
also page 83.
The following figure shows the terminology used to guide you to the required point.
L-O from Line
Select this option to measure distance and offset values along a specified line.
1. Press
[2] or select L-O from Line from the
Layout menu.
2. Enter the first point for the reference line.
Alternatively, select the
MSR softkey to measure a
point.
If you press
[ESC] in the Record PT screen, the
measured point is used but not recorded in the
job.
3. Enter the second point for the reference line.
4. Enter an asterisk ( for example, A*) in the PT field to perform a wildcard search.
A list of matching points appears. Highlight a point in the list and then press
[ENT].
Fill
Out
Cut
L
R
In
In
Out
R
L
Fill
Cut