User's Manual

5 Menu Screen
90 Trimble TS635 Construction Total Station User Guide
Settings (basic job settings)
Use the Settings menu to configure the basic job
settings.
Press
[2] or select Settings on the MENU screen.
Some job settings, as identified in the following
sections, cannot be changed once a job is created. If
you attempt to change any of these settings while a job
is open, a confirmation screen appears, asking you to
create a new job with the new settings, or to work with
the new settings without recording any data. See
Settings, page 126.
Angle
To change the angles, press [1] or select Angle in the
Settings menu.
The VA zero job setting cannot be changed once a job is created.
Distance
These settings cannot be changed once a job is created.
To change the distance, press
[2] or select Distance in the Settings menu.
VA zero Zenith / Horizon
Resolution 1" / 5" / 10"
0.2/ 1/ 2mgon
0.005 / 0.02 / 0.05 mil
Scale Numeric value between 0.999600 and
1.000400
T-P corr ON / OFF
Sea Level ON / OFF
C&R corr OFF / 0.132 / 0.200