User's Manual

3 Getting Started
48 Total Station Nivo Series Instruction Manual
If the average count is set to 0, measurements are taken
continuously until you press
[MSR1], [MSR2], or [ESC]. Each
time a measurement is taken, the distance is updated.
If the average count is set to a value from 1 to 99, the
averaged distance appears after the last shot. The field
name SD changes to SDx
to indicate the averaged data.
Measurement settings
To view the measurement settings,hold down [MSR1] or
[MSR2] for one second.
Use
[^] or [v] to move the cursor between the fields. Use
[<] or [>] to change the value in the selected field.
Target field
If the measurement is started with the Target field set
to Prism, there is a dash “–” in front of the prism
constant.
If the measurement is started with the Target field set
to N-prism, there is a square bracket “]” in front of the
prism constant.
To change the height of target (HT), temperature, or pressure, press [HOT]. For
more information, see [HOT] key, page 34.
Settings that relate to corrections
(T-P corr, Sea Level, C&R corr., and Map projection) are included in the job
settings. These settings are job-specific. If you need to change any of these
settings, you must create a new job. For more information, see Job settings,
page 93, and Settings, page 108.
Field Values
Ta r g e t • Pr i s m
• N-prism
Const (prism constant) –999 mm through 999 mm
Mode • Precise
•Normal
AVE (Average count) 0 (Continuous) through 99
Rec mode One of the following:
•MSR only
•Confirm
•ALL