User's Manual

Total Station Nivo Series Instruction Manual 63
Applications 4
3. Choose how you want to define a known line:
– To define the line by entering P2
coordinates, press
[1] or select By Coord.
– To define the line by entering the azimuth,
press
[2] or select By Angle.
4. If you select
By Angle, the azimuth input
screen appears. Enter the angle value and press
[ENT].
A measurement screen appears.
5. Sight P2 and press
[MSR1] or [MSR2] to take a
measurement. Press
[ENT].
After the measurement to P2 is completed, the
coordinates of the station are calculated.
6. To record the station, press
[ENT] or the REC
softkey.
7. To check your measurement, press the
DSP
softkey. If you defined the line by entering its
azimuth, HD and VD between P1 and P2 are
displayed.
If you defined the line by entering the P2
coordinates, the difference of HD (dHD) and
VD (dZ) between your measurement data and input coordinate data are
displayed.
8. Enter the station name, the height of instrument
(HI), and a feature code (CD) if required. The
station name defaults to the last recorded PT + 1,
or last recorded ST + 1, depending on the Split
ST setting.
9. Backsight (BS) defaults to the first point (P1).
To change it, highlight the BS field and then
press the
Change softkey.
10. To finish the setup and record the station, press
[ENT] in the BS field.