User Manual

If the LCD shows Hl, this means the scene is too bright and

there s no shutter speed to match the aperture you selected. In

this case, overexposure may occur. To prevent this, stop the

lens down until Hl disappears, if all else fails, attach a neutral

density (ND) filter to the lens or change to a slower speed film.

If the LCD displays Lo, the scene is too dark and there is no

shutter speed to match the aperture you selected In this case,

underexposure may occur. To prevent this, select a wider

aperture or, if necessary, attach an electronic flash. As a last

resort, change to a faster film.

Warning Indications

Look through the viewfinder and check the exposure

information. The aperture you set is shown through the

ADR window . When the shutter speed selected by the cam-

era to obtain correct exposure with the aperture you set. If nec-

essary, use a wider aperture to prevent a slow shutter speed

from causing blurred images. (For additional information on

avoiding blurred images, see page 46.)