User Manual
Table Of Contents
- Q&A Index
- Quick Start Guide
- Menu Options
- Table of Contents
- For Your Safety
- Notices
- Introduction
- Basic Photography and Playback
- P, S, A, and M Modes
- User Settings: U1 and U2 Modes
- Release Mode
- Image Recording Options
- Focus
- ISO Sensitivity
- Exposure
- White Balance
- Image Enhancement
- Flash Photography
- Remote Control Photography
- Other Shooting Options
- Live View Photography
- Movie Live View
- Special Effects
- More on Playback
- Connections
- Menu Guide
- The Playback Menu: Managing Images
- The Shooting Menu: Shooting Options
- Custom Settings: Fine-Tuning Camera Settings
- The Setup Menu: Camera Setup
- The Retouch Menu: Creating Retouched Copies
- My Menu/Recent Settings
- Technical Notes
317
n
A Use a Reliable Power Source
The shutter curtain is delicate and easily damaged.
If the camera powers off while the mirror
is raised, the curtain will close automatically.
To prevent damage to the curtain, observe the
following precautions:
• Do not turn the camera off or remove or disconnect the power source while the mirror is
raised.
• If the battery runs low while the mirror is raised, a beep will sound and the self-timer lamp
will flash to warn that the shutter curtain will close and the mirror will be lowered after
about two minutes.
End cleaning or inspection immediately.
D Foreign Matter on the Image Sensor
Nikon takes every possible precaution to prevent foreign matter from coming into contact
with the image sensor during production and shipping.
The D7100, however, is designed to
be used with interchangeable lenses, and foreign matter may enter the camera when lenses
are removed or exchanged.
Once inside the camera, this foreign matter may adhere to the
image sensor, where it may appear in photographs taken under certain conditions.
To
protect the camera when no lens is in place, be sure to replace the body cap provided with
the camera, being careful to first remove all dust and other foreign matter that may be
adhering to the body cap.
Avoid exchanging lenses in dusty environments.
Should foreign matter find its way onto the image sensor, clean the sensor as described
above, or have the sensor cleaned by authorized Nikon service personnel.
Photographs
affected by the presence of foreign matter on the sensor can be retouched using
Capture NX 2 (available separately; 0 309) or the clean image options available in some
third-party imaging applications.