User Manual
Table Of Contents
- Q&A Index
- Quick Start Guide
- Menu Options
- Table of Contents
- For Your Safety
- Notices
- Introduction
- Basic Photography and Playback
- P, S, A, and M Modes
- User Settings: U1 and U2 Modes
- Release Mode
- Image Recording Options
- Focus
- ISO Sensitivity
- Exposure
- White Balance
- Image Enhancement
- Flash Photography
- Remote Control Photography
- Other Shooting Options
- Live View Photography
- Movie Live View
- Special Effects
- More on Playback
- Connections
- Menu Guide
- The Playback Menu: Managing Images
- The Shooting Menu: Shooting Options
- Custom Settings: Fine-Tuning Camera Settings
- The Setup Menu: Camera Setup
- The Retouch Menu: Creating Retouched Copies
- My Menu/Recent Settings
- Technical Notes
30
X
Insert a Memory Card
The camera stores pictures on Secure Digital (SD) memory cards (available separately;
0 347).
To install a memory card, turn the camera off and, holding the card in the
orientation shown below, slide it in until it clicks into place.
The memory card access
lamp will light for a few seconds.
Note that the camera has two memory card slots
(Slot 1 and Slot 2); if you will be using only one memory card, insert it in Slot 1.
Format memory cards before first use or after they have been used in other devices
(0 32).
Inserting memory cards upside down or backwards could damage the camera or the
card.
Check to be sure the card is in the correct orientation.
The card slot cover will
not close if the card is not correctly inserted.
A Removing Memory Cards
After confirming that the memory card access lamp is off, turn the
camera off, open the memory card slot cover, and press the card in to
eject it (q).
The card can then be removed by hand (w).
A No Memory Card
If the camera is turned off with a charged EN-EL15 battery and no
memory card inserted, S will be displayed in the control panel
and viewfinder.
8
GB
Front
Slot 1 Slot 2
8
GB