User Manual
Table Of Contents
- Q&A Index
- Quick Start Guide
- Menu Options
- Table of Contents
- For Your Safety
- Notices
- Introduction
- Basic Photography and Playback
- P, S, A, and M Modes
- User Settings: U1 and U2 Modes
- Release Mode
- Image Recording Options
- Focus
- ISO Sensitivity
- Exposure
- White Balance
- Image Enhancement
- Flash Photography
- Remote Control Photography
- Other Shooting Options
- Live View Photography
- Movie Live View
- Special Effects
- More on Playback
- Connections
- Menu Guide
- The Playback Menu: Managing Images
- The Shooting Menu: Shooting Options
- Custom Settings: Fine-Tuning Camera Settings
- The Setup Menu: Camera Setup
- The Retouch Menu: Creating Retouched Copies
- My Menu/Recent Settings
- Technical Notes
38
s
A The Shutter-Release Button
The camera has a two-stage shutter-release button.
The camera focuses when the shutter-
release button is pressed halfway.
To take the photograph, press the shutter-release button
the rest of the way down.
Focus: press halfway Shoot: press all the way down
A The Standby Timer
The viewfinder and the control panel shutter speed and aperture displays will turn off if no
operations are performed for about 6 seconds, reducing the drain on the battery.
Press the
shutter-release button halfway to reactivate the display.
The length of time before the
standby timer expires automatically can be selected using Custom Setting c2 (Standby
timer, 0 237).
Exposure meters on Exposure meters off Exposure meters on
A Camera Off Display
If the camera is turned off with a battery and memory card inserted,
the memory card icon and number of exposures remaining will be
displayed (some memory cards may in rare cases only display this
information when the camera is on).
A The Built-in Flash
If additional lighting is required for correct exposure in i mode, the
built-in flash will pop up automatically when the shutter-release
button is pressed halfway.
If the flash is raised, photographs can only
be taken when the flash-ready indicator (M) is displayed.
If the flash-
ready indicator is not displayed, the flash is charging; remove your
finger briefly from the shutter-release button and try again.
To save power when the flash is not in use, press it gently downward
until the latch clicks into place.
Control panel