Owner's Manual
Table Of Contents
- Users Manual
- Q&A Index
- Menu Options
- Memory Card Compatibility
- Table of Contents
- Supplied Accessories
- Parts & Controls
- Introduction
- Basic Photography and Playback
- Live View Photography
- Movie Live View
- P, S, A, and M Modes
- User Settings: U1 and U2 Modes
- Release Mode
- Image Recording Options
- Focus
- ISO Sensitivity
- Exposure
- White Balance
- Image Enhancement
- Flash Photography
- Other Shooting Options
- More on Playback
- Connections
- Menu Guide
- The Playback Menu: Managing Images
- The Shooting Menu: Shooting Options
- Custom Settings: Fine-Tuning Camera Settings
- The Setup Menu: Camera Setup
- The Retouch Menu: Creating Retouched Copies
- My Menu / Recent Settings
- Technical Notes
- Troubleshooting
- Specs
- Index
- Scan of CD-ROM
- Warranty
239
U
6 Compose the shot.
Compose the shot and arrange the flash units as shown below.
Note that the
maximum distance at which the remote flash units can be placed may vary with
shooting conditions.
7 Configure the remote flash units.
Turn all the remote flash units on, adjust group settings as desired, and set them
to the channel selected in Step 4. See the flash unit instruction manuals for
details.
8 Raise the built-in flash.
Press the M (Y) button to raise the built-in flash.
Note that even if –– is
selected for Built-in flash>Mode, the built-in flash must be raised so that
monitor preflashes will be emitted.
9 Frame the photograph, focus, and shoot.
After confirming that the camera flash-ready light and the flash-ready lights for
all other flash units are lit, frame the photograph, focus, and shoot.
FV lock
(0 149) can be used if desired.
60 ° or less
30 ° or less10 m/33 ft
or less
30 ° or less
60 ° or less
5m/15ft
or
less
5m/15ft
or less
Camera
(built-in flash)
Wireless remote sensors
on flash units should face
camera.