Owner's Manual
Table Of Contents
- User Manual
- Reset
- Compatible Lenses
- Memory Card Compatibility
- Table of Contents
- Supplied Accessories
- Parts & Controls
- Introduction
- Basic Photography and Playback
- Matching Settings to the Subject or Situation (Scene Mode)
- Special Effects
- P, S, A, and M Modes
- User Settings: U1 and U2 Modes
- Release Mode
- Image Recording Options
- Focus
- ISO Sensitivity
- Exposure
- White Balance
- Image Enhancement
- Flash Photography
- Remote Control Photography
- Recording and Viewing Movies
- Other Shooting Options
- More on Playback
- Wi-Fi
- Menu List
- Technical Notes
- Troubleshooting
- Error Messages
- Specs
- Index
- Warranty
220
3 Start shooting.
Highlight Start and press J.
The first
series of shots will be taken at the
specified starting time, or after about
3s if Now was selected for Start
options in Step 2.
Shooting will
continue at the selected interval until
all shots have been taken.
A During Shooting
During interval timer photography, the
memory card access lamp will flash.
Immediately before the next shooting
interval begins, the shutter speed display
will show the number of intervals remaining,
and the aperture display will show the
number of shots remaining in the current
interval.
At other times, the number of
intervals remaining and the number of shots
in each interval can be viewed by pressing
the shutter-release button halfway (once the button is released, the
shutter speed and aperture will be displayed until the standby timer
expires).
Settings can be adjusted, the menus used, and pictures played back
while interval timer photography is in progress. The monitor will turn
off automatically about four seconds before each interval.
Note that
changing camera settings while the interval timer is active may cause
shooting to end.
A Release Mode
Regardless of the release mode selected, the camera will take the
specified number of shots at each interval.
Memory card
access lamp