Owner's Manual

361
n
Live view ends unexpectedly or does not start: Live view may end automatically to
prevent damage to the camera’s internal circuits if:
• The ambient temperature is high
• The camera has been used for extended periods in live view or to record
movies
• The camera has been used in continuous release modes for extended
periods
If live view does not start when you press the a button, wait for the
internal circuits to cool and then try again.
Note that the camera may feel
warm to the touch, but this does not indicate a malfunction.
Image artifacts appear during live view: “Noise” (randomly-spaced bright pixels,
fog, or lines) and unexpected colors may appear if you zoom in on the view
through the lens (0 47) during live view; in movies, the amount and
distribution of randomly-spaced bright pixels, fog, and bright spots are
affected by frame size and rate (0 67).
Randomly-spaced bright pixels,
fog, or bright spots may also arise as a result of increases in the
temperature of the camera’s internal circuits during live view; exit live view
when the camera is not in use.
Can not measure white balance: Subject is too dark or too bright (0 169).
Image can not be selected as source for preset white balance: Image was not created
with D5 (0 176).
White balance bracketing unavailable:
• NEF (RAW) or NEF+JPEG image quality option selected for image quality
(0 92).
• Multiple exposure mode is in effect (0 229).
Photographs and movies do not appear to have the same exposure as the preview shown
in the monitor during live view: Changes to monitor brightness during live view
have no effect on images recorded with the camera (0 51).
Effects of Picture Control differ from image to image: A (auto) is selected for
sharpening, clarity, contrast, or saturation.
For consistent results over a
series of photographs, choose another setting (0 183).