User Manual
Table Of Contents
- Table of Contents
- For Your Safety
- Notices
- Bluetooth and Wi-Fi (Wireless LAN)
- Introduction
- First Steps
- Tutorial
- Basic Photography and Playback
- Matching Settings to the Subject or Situation (Scene Mode)
- Special Effects
- More on Photography
- P, S, A, and M Modes
- Recording and Viewing Movies
- Playback and Deletion
- Connections
- Camera Menus
- The Playback Menu: Managing Images
- The Shooting Menu: Shooting Options
- Custom Settings: Fine-Tuning Camera Settings
- The Setup Menu: Camera Setup
- Setup Menu Options
- Format Memory Card
- Image Comment
- Copyright Information
- Time Zone and Date
- Language
- Beep Options
- Touch Controls
- Monitor Brightness
- Info Display Format
- Auto Info Display
- Info Display Auto Off
- Image Dust Off Ref Photo
- Flicker Reduction
- Slot Empty Release Lock
- Location Data
- Remote Control
- Airplane Mode
- Connect to Smart Device
- Send to Smart Device (Auto)
- Wi-Fi
- Bluetooth
- Eye-Fi Upload
- Conformity Marking
- Firmware Version
- Setup Menu Options
- The Retouch Menu: Creating Retouched Copies
- Recent Settings/My Menu
- Technical Notes
101More on Photography
The camera supports a variety of flash modes for photographing
poorly lit or backlit subjects.
Auto Pop-up Modes
In i, k, p, n, o, s, w, S, T, U, and ' modes, the built-in flash
automatically pops up and fires as required.
1 Choose a flash mode.
Keeping the M (Y) button pressed, rotate the command dial
until the desired flash mode appears in the information
display.
2 Take pictures.
The flash will pop up as
required when the shutter-
release button is pressed
halfway, and fire when a
photograph is taken.
If the
flash does not pop up
automatically,
DO NOT attempt to raise it by hand.
Failure to
observe this precaution could damage the flash.
Using the Built-in Flash
M (Y) button Command dial Information display
+