User Manual
Table Of Contents
- Table of Contents
- For Your Safety
- Notices
- Bluetooth and Wi-Fi (Wireless LAN)
- Introduction
- First Steps
- Tutorial
- Basic Photography and Playback
- Matching Settings to the Subject or Situation (Scene Mode)
- Special Effects
- More on Photography
- P, S, A, and M Modes
- Recording and Viewing Movies
- Playback and Deletion
- Connections
- Camera Menus
- The Playback Menu: Managing Images
- The Shooting Menu: Shooting Options
- Custom Settings: Fine-Tuning Camera Settings
- The Setup Menu: Camera Setup
- Setup Menu Options
- Format Memory Card
- Image Comment
- Copyright Information
- Time Zone and Date
- Language
- Beep Options
- Touch Controls
- Monitor Brightness
- Info Display Format
- Auto Info Display
- Info Display Auto Off
- Image Dust Off Ref Photo
- Flicker Reduction
- Slot Empty Release Lock
- Location Data
- Remote Control
- Airplane Mode
- Connect to Smart Device
- Send to Smart Device (Auto)
- Wi-Fi
- Bluetooth
- Eye-Fi Upload
- Conformity Marking
- Firmware Version
- Setup Menu Options
- The Retouch Menu: Creating Retouched Copies
- Recent Settings/My Menu
- Technical Notes
378 Technical Notes
❚❚ Supplied Accessories
• LC-58 58 mm Snap-on Front Lens Cap
• Rear Lens Cap
❚❚ Compatible Accessories
• 58 mm screw-on filters
• LF-4 Rear Lens Cap
• CL-1020 Lens Case
• HB-77 Bayonet Hood
Align the lens hood mounting mark (●) with the lens hood
alignment mark ( ) as shown in Figure q and then rotate
the hood (w) until the ● mark is aligned with the lens hood
lock mark (—).
When attaching or removing the hood, hold it near the
symbol on its base and avoid gripping it too tightly.
Vignetting may occur if the hood is not correctly attached.
The hood can be reversed and mounted on the lens when not
in use. When the hood is reversed, it can be attached and
removed by rotating it while holding it near the lock mark
(—).