User Manual
Table Of Contents
- Table of Contents
- For Your Safety
- Notices
- Bluetooth and Wi-Fi (Wireless LAN)
- Introduction
- First Steps
- Tutorial
- Basic Photography and Playback
- Matching Settings to the Subject or Situation (Scene Mode)
- Special Effects
- More on Photography
- P, S, A, and M Modes
- Recording and Viewing Movies
- Playback and Deletion
- Connections
- Camera Menus
- The Playback Menu: Managing Images
- The Shooting Menu: Shooting Options
- Custom Settings: Fine-Tuning Camera Settings
- The Setup Menu: Camera Setup
- Setup Menu Options
- Format Memory Card
- Image Comment
- Copyright Information
- Time Zone and Date
- Language
- Beep Options
- Touch Controls
- Monitor Brightness
- Info Display Format
- Auto Info Display
- Info Display Auto Off
- Image Dust Off Ref Photo
- Flicker Reduction
- Slot Empty Release Lock
- Location Data
- Remote Control
- Airplane Mode
- Connect to Smart Device
- Send to Smart Device (Auto)
- Wi-Fi
- Bluetooth
- Eye-Fi Upload
- Conformity Marking
- Firmware Version
- Setup Menu Options
- The Retouch Menu: Creating Retouched Copies
- Recent Settings/My Menu
- Technical Notes
27First Steps
Insert the Battery and a Memory Card
Before inserting or removing the battery or memory cards,
confirm that power switch is in the OFF position.
Insert the
battery as shown, using the battery to keep the orange battery
latch pressed to one side.
The latch locks the battery in place
when the battery is fully inserted.
Holding the memory card in the orientation shown, slide it in
until it clicks into place.
Battery latch
A The Clock Battery
The camera clock is powered by an independent, rechargeable power
source, which is charged as necessary when the main battery is
installed.
Three days of charging will power the clock for about a
month.
If a message warning that the clock is not set is displayed
when the camera is turned on, the clock battery is exhausted and the
clock has been reset.
Set the clock to the correct time and date.