Owner's Manual

78 Menu Guide
❚❚ Ending Shooting
To end shooting before all the photos are taken, highlight Off in
the time-lapse movie menu and press J, or press J between
frames or immediately after a frame is recorded. A movie will be
created from the frames shot to the point where shooting
ended. Note that shooting will end and no movie will be
recorded if the power source is removed or disconnected or the
memory card is ejected.
❚❚ No Photograph
The camera will skip the current frame if it is unable to focus
using single-servo autofocus (AF-S or single-servo autofocus
selected for AF-A) or with Focus selected for Custom Setting a1
(AF-C priority selection) in AF-C (note that the camera focuses
again before each shot). Shooting will resume with the next
frame.
D Time-Lapse Movies
Time-lapse is not available during live view or movie recording, at a
shutter speed of A or %, in special effects mode, or when the self-
timer, bracketing (0 49), High Dynamic Range (HDR, 0 57), multiple
exposure (0 50), or interval timer photography (0 58) is active. Note
that because shutter speed and the time needed to record the image
to the memory card may vary from shot to shot, the interval between
a shot being recorded and the start of the next shot may vary.
Shooting will not begin if a time-lapse movie can not be recorded at
current settings (for example, if the memory card is full, the interval or
shooting time is zero, or the interval is longer than the shooting time).
Shooting may end if camera controls are used or settings are changed
or HDMI cable is connected. A movie will be created from the frames
shot to the point where shooting ended. To end shooting and record a
photograph, press the shutter-release button all the way down.