User Manual
Table Of Contents
- Package Contents
- Table of Contents
- For Your Safety
- Notices
- Getting to Know the Camera
- First Steps
- Basic Photography and Playback
- Basic Settings
- Shooting Controls
- The i Button
- Menu List
- The Playback Menu: Managing Images
- The Photo Shooting Menu: Shooting Options
- Reset photo shooting menu
- Storage folder
- File naming
- Choose image area
- Image quality
- Image size
- NEF (RAW) recording
- ISO sensitivity settings
- White balance
- Set Picture Control
- Manage Picture Control
- Color space
- Active D-Lighting
- Long exposure NR
- High ISO NR
- Vignette control
- Diffraction compensation
- Auto distortion control
- Flicker reduction shooting
- Metering
- Flash control
- Flash mode
- Flash compensation
- Focus mode
- AF-area mode
- Vibration reduction
- Auto bracketing
- Multiple exposure
- HDR (high dynamic range)
- Interval timer shooting
- Time-lapse movie
- Focus shift shooting
- Silent photography
- The Movie Shooting Menu: Movie Shooting Options
- Reset movie shooting menu
- File naming
- Choose image area
- Frame size/frame rate
- Movie quality
- Movie file type
- ISO sensitivity settings
- White balance
- Set Picture Control
- Manage Picture Control
- Active D-Lighting
- High ISO NR
- Vignette control
- Diffraction compensation
- Auto distortion control
- Flicker reduction
- Metering
- Focus mode
- AF-area mode
- Vibration reduction
- Electronic VR
- Microphone sensitivity
- Attenuator
- Frequency response
- Wind noise reduction
- Headphone volume
- Timecode
- Custom Settings: Fine-Tuning Camera Settings
- Reset custom settings
- a Autofocus
- a1 AF-C priority selection
- a2 AF-S priority selection
- a3 Focus tracking with lock-on
- a4 Auto-area AF face detection
- a5 Focus points used
- a6 Store points by orientation
- a7 AF activation
- a8 Limit AF-area mode selection
- a9 Focus point wrap-around
- a10 Focus point options
- a11 Low-light AF
- a12 Built-in AF-assist illuminator
- a13 Manual focus ring in AF mode
- b Metering/exposure
- c Timers/AE lock
- d Shooting/display
- e Bracketing/flash
- f Controls
- g Movie
- The Setup Menu: Camera Setup
- Format memory card
- Save user settings
- Reset user settings
- Language
- Time zone and date
- Monitor brightness
- Monitor color balance
- Viewfinder brightness
- Viewfinder color balance
- Control panel brightness
- Limit monitor mode selection
- Information display
- AF fine-tune
- Non-CPU lens data
- Clean image sensor
- Image Dust Off ref photo
- Image comment
- Copyright information
- Beep options
- Touch controls
- HDMI
- Location data
- Wireless remote (WR) options
- Assign remote (WR) Fn button
- Airplane mode
- Connect to smart device
- Connect to PC
- Wireless transmitter (WT-7)
- Conformity marking
- Battery info
- Slot empty release lock
- Save/load settings
- Reset all settings
- Firmware version
- The Retouch Menu: Creating Retouched Copies
- My Menu/Recent Settings
- Troubleshooting
- Technical Notes
- The Camera Display and Control Panel
- The Nikon Creative Lighting System
- Other Accessories
- Caring for the Camera
- Caring for the Camera and Battery: Cautions
- Specifications
- NIKKOR Z 24–70mm f/4 S Lens User’s Manual
- FTZ Mount Adapter User’s Manual
- Approved Memory Cards
- Memory Card Capacity
- Battery Endurance
- Notices
- Bluetooth and Wi-Fi (Wireless LAN)
- Index
158 Troubleshooting
Solutions to some common issues are listed below.
Battery/Display
Problems and Solutions
The camera is on but does not respond: Wait for recording to end. If the
problem persists, turn the camera off. If the camera does not turn off,
remove and reinsert the battery or, if you are using an AC adapter,
disconnect and reconnect the AC adapter. Note that although any data
currently being recorded will be lost, data that have already been
recorded will not be affected by removing or disconnecting the power
source.
The viewfinder or monitor does not turn on: Choose a different monitor mode
using the monitor mode button.
The viewfinder is out of focus: Rotate the diopter adjustment control to focus
the viewfinder. If this does not correct the problem, select AF-S, single-
point AF, and the center focus point, and then frame a high-contrast
subject in the center focus point and press the shutter-release button
halfway to focus the camera. With the camera in focus, use the diopter
adjustment control to bring the subject into clear focus in the
viewfinder.
The displays turn off without warning: Choose longer delays for Custom
Setting c3 (Power off delay).
The control panel is unresponsive and dim: Control panel response times and
brightness vary with temperature.