Owner's Manual
Table Of Contents
- Instruction Manual
- Introduction
- Getting to know the Laser Rangefinder
- Functions
- Inserting/Replacing battery
- Navigating the menus
- Operation diagram of the setting menus (PROSTAFF 1000i)
- Changing the distance display unit (F1) (PROSTAFF 1000i)
- Changing the measurement display mode (F2) (PROSTAFF 1000i)
- Changing the target priority mode (F3) (PROSTAFF 1000i)
- Operation diagram of the setting menus (PROSTAFF 1000)
- Changing the distance display unit (F1) (PROSTAFF 1000)
- Changing the target priority mode (F2) (PROSTAFF 1000)
- Measurement
- Technical notes
- Warranty
21
En
Fr
Single measurement
Pressing the PWR button once starts single measurement, then displays the results.
• If measurement fails, measurement continues automatically for up to about 4 seconds until results are
obtained. Measurement stops when it is successful, even within about 4 seconds.
Example of measured
distance display
Example of measurement
failure
Continuous measurement
Press and hold down the PWR button to start continuous measurement up to approx. 8 seconds. During
measurement, the measured result is displayed consecutively while the laser irradiation mark is blinking. If
you release your finger from the button, continuous measurement stops.
Standby
Continuous measurement
Press the PWR button once
Press and hold down the PWR
button
Single measurement*
* If measurement fails, measurement continues automatically for up to about 4 seconds until results are obtained.