NIKKOR Z DX 16-50mm f/3.5-6.
Before using this product, please read these instructions carefully. You will also need to consult the camera manual. • This lens is intended exclusively for use with mirrorless cameras featuring a Nikon Z mount. • Update to the latest version of the camera firmware before using this lens with the Z 7 or Z 6, as otherwise the camera may fail to correctly recognize the lens and features such as vibration reduction may be unavailable. The latest firmware is available from the Nikon Download Center.
A WARNING • Keep dry. Do not handle with wet hands. Failure to observe these precautions could result in fire or electric shock. • Do not use this product in the presence of flammable dust or gas such as propane, gasoline or aerosols. Failure to observe this precaution could result in explosion or fire. • Do not directly view the sun or other bright light source through the lens. Failure to observe this precaution could result in visual impairment. • Keep this product out of reach of children.
A CAUTION • Do not transport cameras or lenses with tripods or similar accessories attached. Failure to observe this precaution could result in injury or product malfunction. Notices for Customers in the U.S.A. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
CAUTIONS Modifications The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Nikon Corporation may void the user’s authority to operate the equipment. Nikon Inc., 1300 Walt Whitman Road, Melville, New York 11747-3064, U.S.A. Tel.
Using the Lens Parts of the Lens: Names and Functions See below for the names and functions of the parts of the lens.
Lens hoods block stray light that would otherwise cause flare or ghosting. They also serve to protect the lens. Rotate to zoom in or out. Be sure to w Zoom ring extend the lens before use. e Focal length scale Determine the approximate focal length when zooming the lens in or r Focal length mark out. Autofocus mode selected: In autofocus mode, rotate the ring to adjust a setting such as [Focus (M/A)] or [Aperture] assigned using the camera.
A Attachment and Removal Attaching the Lens z Turn the camera off, remove the body cap, and detach the rear lens cap. x Position the lens on the camera body, keeping the mounting mark on the lens aligned with the mounting mark on the camera body, and then rotate the lens counterclockwise until it clicks into place. Removing the Lens z Turn the camera off. x Press and hold the lens release button while turning the lens clockwise.
B Before Use The lens is retractable and must be extended before use. Rotate the zoom ring as shown until the lens clicks into the extended position. Pictures can only be taken when the focal length mark points to positions between 16 and 50 on the focal length scale. Pictures can be taken at these focal lengths To retract the lens, rotate the zoom ring in the opposite direction, stopping when you reach the (●) position on the focal length scale.
C Attaching and Removing Optional Lens Hoods Lens hoods (available separately) screw directly into the threads in front of the lens. Do not touch the glass surface of the lens or use excessive force. To remove the hood, unscrew it from the lens.
Using the Lens on Cameras with a Built-in Flash Shadows will be visible in photos where the light from the built-in flash is obscured by the lens or lens hood. Remove the lens hood before shooting. Note, however, that even if the hood is removed, shadows may still be visible at some focal lengths and subject distances. Vibration Reduction (VR) The lens’s on-board vibration reduction can be enabled or disabled using camera controls; see the camera manual for details.
When the Lens Is Attached • The focus position may change if you turn the camera off and then on again after focusing. If you have focused on a pre-selected location while waiting for your subject to appear, we recommend that you do not turn the camera off until the picture is taken. • Mounting this lens on an FX-format camera: - selects the DX image area, reducing the available focus points and number of pixels recorded, and - disables the [Image Dust Off ref photo] option in the setup menu.
Precautions for Use • • • • • Do not pick up or hold the lens or camera using only the lens hood. Keep the CPU contacts clean. Replace the front and rear lens caps when the lens is not in use. To protect the interior of the lens, store it out of direct sunlight. Do not leave the lens in humid locations or in locations in which it may be exposed to moisture. Rusting of the internal mechanism can cause irreparable damage. • Do not leave the lens next to open flames or in other extremely hot locations.
Lens Care • Removing dust is normally sufficient to clean the glass surfaces of the lens. • Smudges, fingerprints, and other oily stains can be removed from the lens surface using a soft, clean cotton cloth or lens cleaning tissue lightly dampened with a small amount of ethanol or lens cleaner. Wipe gently from the center outwards in a circular motion, taking care not to leave smears or touch the lens with your fingers. • Never use organic solvents such as paint thinner or benzene to clean the lens.
Accessories Supplied Accessories • LC-46B 46 mm snap-on Front Lens Cap • LF-N1 Rear Lens Cap Compatible Accessories • CL-C4 Lens Case • HN-40 Screw-on Lens Hood • 46 mm screw-on filters D Filters • Use only one filter at a time. • Remove the lens hood before attaching filters.
Specifications Mount Focal length Maximum aperture Lens construction Nikon Z mount 16 – 50 mm f/3.5 – 6.3 9 elements in 7 groups (including 1 ED element and 4 aspherical elements) Angle of view 83°–31° 30' (DX image area) Focal length scale Graduated in millimeters (16, 24, 35, 50) Focusing system Internal focusing system Vibration reduction Lens shift using voice coil motors (VCMs) Minimum focus distance • 16 mm zoom position: 0.25 m (0.82 ft) (measured from focal • 24 mm zoom position: 0.2 m (0.