Owner's Manual

Monitor
AF button
Press the AF button and rotate the command
dial until one
of the following autofocus modes
is displayed in the monitor (note that these
autofocus modes differ from those available in
other shooting modes):
Mode'T ················Descrlpilon .
----.- --.---- .. i·Th-eEa m-era"autom'atica,'rydetects"'-"--
[!] Fa~e . !and focuses on portrait subjects
pnonty
:facing the camera. Use for portraits.
...... ·······!Useforhand~heidshotsoffandscapes
~ iJ Wide area: and other non-portrait subjects. The
WIDE (default) 'focus point can be selected using the
• multi selector.
................................. .;..
, Use for pin-point focus on a selected
[,,] Normal. h f d
NClllI ,spot in t e rame. A tripo is
area
.recommended.
2 Choose an autofocus mode.
3 Check the view in the monitor.
To magnify the view in the monitor and check focus, press the ~ button.
Press ~ to zoom in up to a maximum of 6.7 x, or press ~~ to zoom out. While
the view
through the lens is zoomed in, a navigation window will appear in a
gray frame at the
bottom right corner of the display. Use the multi selector to
scroll to areas of the frame not visible in the monitor. Press ® to exit zoom.
• Monitor Brightness
Monitor brightness can be adjusted by pressing the [B button while the view through the
monitor is displayed. Press A or T to adjust brightness (note that monitor brightness has no
effect on pictures taken in live view mode).
To return to live view, release the [B button.
44