Owner's Manual

When the camera is ready to measure white
balance, a flashing ::',- E (PRE) will appear in
the viewfinder and information display.
\ I I.
:~S fS.6 Pr E
/ I \
5 Measure white balance.
Before the indicators stop flashing, frame the
reference object so that it fills the viewfinder
and press the shutter-release button all the
way down. No photograph will be recorded; white balance can be measured
accurately even when the camera is not in focus.
/1\
~i!..
no Gd PrE
Gd PrE
'" \ I /
/ I \
""
6 Check the results.
If the camera was able to measure a value for
white balance, the message shown at right
will be displayed and GC: will flash in the
viewfinder for about eight seconds before
the camera returns to shooting mode. To
return to shooting mode immediately, press
the shutter-release button halfway.
If lighting is too dark or too bright, the
camera may be unable to measure white
balance. A message will appear in the
information display and a flashing '-leI GC:
will appear in the viewfinder. Press the
shutter-release button halfway to return to
Step 4 and measure white balance again.
.. ~~~
,
-~ ~~ ~.:
100