Owner's Manual

285
n
❚❚ “Clean at Startup/Shutdown”
Choose from the following options:
1 Select Clean at startup/shutdown.
Display the Clean image sensor menu as
described in Step 2 on the previous page.
Highlight Clean at startup/shutdown and
press 2.
2 Select an option.
Highlight an option and press J.
Option Description
5 Clean at startup
The image sensor is automatically cleaned each time the camera is turned
on.
6
Clean at
shutdown
The image sensor is automatically cleaned during shutdown each time
the camera is turned off.
7
Clean at startup
& shutdown
The image sensor is cleaned automatically at startup and at shutdown.
8 Cleaning off Automatic image sensor cleaning off.
D Image Sensor Cleaning
Using camera controls interrupts image sensor cleaning.
Image sensor cleaning may not be
performed at startup if the flash is charging.
Cleaning is performed by vibrating the low-pass filter.
If dust can not be fully removed using
the options in the Clean image sensor menu, clean the image sensor manually (0 286) or
consult a Nikon-authorized service representative.
If image sensor cleaning is performed several times in succession, image sensor cleaning
may be temporarily disabled to protect the camera’s internal circuitry.
Cleaning can be
performed again after a short wait.