User Manual

E75
Reference Section
Raise the flash.
The flash is lowered.
Raise the flash when shooting in Night portrait or
Backlighting (when HDR is set to k) scene mode.
33, 35,
44
Lens error
The lens cap may be attached, or a lens error occurred.
Make sure that the lens cap has been removed, and turn the
camera off and then on again. If the error persists, contact
your retailer or Nikon-authorized service representative.
4, 20
Communications error
An error occurred while communicating with the printer.
Turn the camera off and reconnect the USB cable.
E19
System error
An error occurred in the camera’s internal circuitry.
Turn the camera off, remove and reinsert the batteries, and
turn the camera on. If the error persists, contact your retailer
or Nikon-authorized service representative.
12, 20
Printer error: check
printer status.
After solving the problem, select Resume and press the
k button to resume printing.*
–
Printer error: check
paper.
Load the specified size of paper, select Resume, and press
the k button to resume printing.*
–
Printer error: paper jam.
Remove the jammed paper, select Resume, and press the
k button to resume printing.*
–
Printer error: out of
paper.
Load the specified size of paper, select Resume, and press
the k button to resume printing.*
–
Printer error: check ink.
There is a problem with the printer’s ink.
Check the ink, select Resume, and press the k button to
resume printing.*
–
Display Cause/Solution
A