User's Manual

38 Transfer, Control, and HTTP
Camera Control
A Ethernet Networks
Do not disconnect the Ethernet cable while the camera is on.
D Wireless Networks
Operations may take longer on wireless networks. If the signal is
disrupted while pictures are being transferred to Camera Control Pro 2,
the LED on the WT-7 will flash orange; turn the camera off and then on
again. Transfer will resume when the connection is re-established. Note
that transfer can not be resumed if you turn the camera off again before
transfer is complete.
A Network Status
The status of the link between the host and the WT-7 is shown by the
status LEDs and by the display in the top level of the network menu.
The Status LEDs
Status POWER LINK ERROR
WT-7 off I (off) I (off) I (off )
USB cable not connected K (on) I (off) I (off )
Connecting to host K (on) K (on) I (off)
Waiting to send or sending data K (on) H (flashes) I (off)
Connection error K (on) I (off) H (flashes)
WT-7 hardware or battery malfunction H (flashes) H (flashes) H (flashes)
The POWER LED lights when the WT-7 is on.
Signal quality is shown by the LINK LED: the
faster the LED flashes, the better the signal and
the faster data can be transmitted. The ERROR
LED flashes to show that an error has occurred.