Manual

TROUBLESHOOTING
Trouble
Camera will not communicate with computer.
Frequent communication errors.
Error message appears when opening a
shooting data file or image file from a DOS-
formatted floppy disk.
"Not enough memory" message appears
during operation.
System error occurs while using "Balloon Help"
with this software.
System error occurs while dragging and
dropping a data file over the Printer icon.
Cause and remedy
If your computer uses a single serial port for
both modem and printer, set it to the modem
port setting. Open the "Tool" menu, select
"Configuration", then set "Communication Port"
at "Modem".
Communication through networks may require
substantial memory and could cause frequent
errors. Deactivating AppleTalk may reduce
errors. Select "Chooser" from the Apple Menu,
then set "AppleTalk" to "Inactive".
Opening a file from a DOS-formatted floppy
disk, formatted on a WindowsO-based
computer, may cause errors. If such an error
occurs, initialize the disk in DOS-format on a
Macintosh® computer.
Insufficient virtual memory may result in a lack
of operating memory. Open "Memory" in the
"Control Panel", then set virtual memory to
"On" to increase the available memory.
This software does not offer "Balloon Help"
support. Do not attempt to activate "Balloon
Help" displays while using this software.
This software does not support the printout
function that allows you to drag and drop data
into the "Printer" icon. Do not attempt to drag
and drop data into the "Printer" icon.
S3