Manuale d'uso

16
En
En
■ Using the lens hood
Attaching the hood
Align the lens hood attachment index (A,
either of two indexes) 2 on the hood with the
lens hood mounting index 4 on the lens, and
turn the hood counterclockwise (as viewed
when holding the camera with the lens facing
away from you) until it clicks into place (Fig. B).
• Be sure that the lens hood mounting index is
aligned with the lens hood setting index
(
B) 3.
• If the lens hood is not correctly attached,
vignetting may occur.
• To facilitate attachment or removal of the
hood, hold it by the base (near the lens hood
attachment index) rather than its outer edge.
• To store the lens hood, attach it in the reverse
position.
Detaching the hood
Hold the lens hood by the base (near the lens
hood attachment index) and turn clockwise, as
viewed when holding the camera with the
lens facing away from you, to detach.
■ Lens care
• Be careful not to allow the CPU contacts a
to become dirty or damaged.
• If the lens mount rubber gasket 0 is
damaged, be sure to visit the nearest Nikon-
authorized service representative for repair.
• Clean lens surfaces with a blower brush. To
remove dirt and smudges, use a soft, clean
cotton cloth or lens tissue moistened with
ethanol (alcohol) or lens cleaner. Wipe in a
circular motion from the center to the outer
edge, taking care not to leave traces or touch
other parts of the lens.
• Never use organic solvent such as thinner or
benzene to clean the lens, as this could cause
damage, result in a fire, or cause health
problems.