Instruction Manual

19
18
EnEn
(4) Adjustment of the riflescope
Sighting through the riflescope, align the rifle with your aiming point on the target and shoot a trial round. If the bullet does not hit the aiming point, adjust the elevation and windage as follows:
•
If the bullet hits under the aiming point, turn the elevation adjustment turret (counter-clockwise) in the direction of the arrow marked “U” for up. If the bullet hits high, turn the elevation adjustment turret (clock-
wise) in the direction of the arrow marked “D” for down.
•
If the bullet hits to the right of the aiming point, turn the windage adjustment turret (clockwise) in the direction of the arrow marked “L” for left. If the bullet hits to the left of the aiming point, turn the windage
adjustment turret (counter-clockwise) in the direction of the arrow marked “R” for right.
•
After the reticle has been adjusted to the point of impact, replace the turret cap for both the windage and elevation adjustment turrets (BLACK FORCE1000 1-4x24 IL SPEEDFORCE only).
(5) Zero setting of adjustment turret
The elevation adjustment and windage adjustment turrets have a retracting system. After the reticle has been adjusted to match the point of impact, pull up the elevation adjustment or windage adjustment turret
to disengage. The turret can now be turned freely. Align the zero number to the index line to set the zero setting, and then release the turret. The turret automatically retracts to the original position.
(6) Adjustable side focus
The BLACK X1000 Riflescope Series includes a side-focus adjustment that allows precise focusing of the reticle on the same focal plane as the target image from 45.7 m (50 yd.) to infinity. Thus, parallax can be
eliminated and sight alignment will be accurate. The marked distance scale can be used as a reference guide.
Note:
•
The windage and elevation scales of BLACK FORCE1000 1-4×24 IL SPEEDFORCE are calibrated in divisions of 1/2 minute of angle (MOA) with a click at intervals of 1/2 minute of angle (1 division).
•
The windage and elevation scales of BLACK X1000 4-16×50SF X-MOA, BLACK X1000 4-16×50SF IL X-MOA, and BLACK X1000 6-24×50SF IL X-MOA are calibrated in divisions of 1/4 minute of angle (MOA) with a
click at intervals of 1/4 minute of angle (1 division).
The windage and elevation scales of BLACK X1000 4-16×50SF IL X-MRAD and BLACK X1000 6-24×50SF IL X-MRAD are calibrated in divisions of 0.1 Millradian (MRAD) per click.
•
When adjusting the reticle to the point of aim, remember that 1 minute of angle (MOA) equals approximately 2.54 cm (1 in.) at 91.44 m (100 yd.).
Therefore, if the impact point is 5.08 cm (2 in.) low and 2.54 cm (1 in.) right at 91.44 m (100 yd.) parallax setting, you should adjust 2 minutes of angle up and 1 minute of angle left.
In the case of 45.72 m (50 yd.) parallax setting, the adjusting value is 2×. In the case of 68.58 m (75 yd.) parallax setting, the adjusting value is 1.5×.
•
When adjusting the reticle to the point of aim, remember that 0.1 Millradian equals approximately 1 cm at 100 m.
Therefore, if the impact point is 2 cm low and 1 cm right at 100 m parallax setting, you should adjust 0.2 Millradian up and 0.1 Millradian left.