Instruction Manual

15
En
Fr
En
Fr
Ru
Se
Ru
Fi
Cz
Ru
Ru
Se
Ru
Fi
Cz
(5) Zero resetting of adjustment turret
After the reticle has been adjusted to match the point of impact, perform the steps described below for each adjustment turret to reset the turret to zero.
The 4-16×50SF is used as an example in the illustrations.
•
For the elevation adjustment turret, you can use the zero stop function. For details, refer to (6) on the next page.
1.
Loosen three screws (
1
) and take off the turret.
 •Becarefulnottooverloosenoritwillcomeoff,butalsonottootightoritwillgetstuckinside(
2
is about the perfect position to stop screwing).
2. Put the turret back to zero position(
3
) and tighten all three screws on the turret.
1
2
3
Hex key
Turret