Instruction Manual

16
En
Fr
En
Fr
Ru
Se
Ru
Fi
Cz
Ru
Ru
Se
Ru
Fi
Cz
(6) Zero stop function of elevation adjustment turret
The elevation adjustment turret integrates a return to zero stop function that prevents you from dialing down past your “0” (for instance, if you specified a 200 yd. zero, the return to zero feature prevents dialing
below 200 yd.).
After the reticle has been adjusted to match the point of impact, perform the steps described below. The 4-16×50SF is used as an example in the illustrations.
1.
Loosen three screws (
1
) and take off the turret.
 •Becarefulnottooverloosenoritwillcomeoff,butalsonottootightoritwillgetstuckinside
(
2
is about the perfect position to stop screwing).
2. Loosen three screws on the zero stop ring (
3
).
3. Bring the zero stop ring down to the bottom (
4
) and tighten three screws on the ring.
4. Put the turret back to zero position (
5
) and tighten all three screws on the turret.
1
2
3
4
5
Hex key
Turret
Zero stop ring