User manual

196
Technical Notes
Troubleshooting
The battery
inserted in the
camera cannot be
charged.
• Confirm all connections. 17
• When connected to a computer, the camera may not
charge for any of the reasons described below.
- Off is selected for Charge by computer in the setup
menu.
175
- Battery charging stops if the camera is turned off. –
- Battery charging is not possible if the camera’s display
language and date and time have not been set, or the
date and time were reset after the camera’s clock
battery was exhausted. Use the Charging AC Adapter to
charge the battery.
20
- Battery charging may stop when the computer enters
sleep mode.
–
- Depending on the computer specifications, settings,
and status, battery charging may not be possible.
–
The monitor is
hard to see.
• The surrounding area is too bright. 26
- Move to a darker place.
- Use the viewfinder.
• Adjust the screen brightness. 163
The viewfinder is
hard to see.
• Adjust the diopter of the viewfinder.
• Adjust the viewfinder brightness.
26
163
The camera does
not switch
between the
monitor and
viewfinder.
• The display does not switch in the following situations:
- While operating the zoom when recording movies
- During movie playback
- When editing movies
• The display may not switch while the camera is being
operated.
–
O flashes on the
screen.
• If the camera clock has not been set, O flashes on the
shooting screen, and images and movies saved before
the clock is set are dated “00/00/0000 00:00” and “01/01/
2019 00:00” respectively.
Set the correct time and date for Time zone and date in
the setup menu.
11, 161
Date and time of
recording are not
correct.
•
The camera clock is not as accurate as ordinary watches or
clocks. Periodically compare the time of the camera clock
with that of a more accurate timepiece and reset as required.
Problem Cause/Solution
A