User's Manual

E71
Reference Section
Error Messages
The following table lists the error messages and other warnings displayed in the
monitor, as well as the solutions for dealing with them.
Display Cause/Solution A
O (flashes)
Clock not set.
Set date and time.
E50
Battery exhausted. Charge or replace the battery. 14, 16
Battery temperature
high
Battery temperature is high.
Turn off camera, and allow battery to cool down before
resuming use. After five seconds, the monitor will turn off
and the power-on lamp will flash rapidly. After the lamps
flash for three minutes, the camera will turn off
automatically. Pressing the power switch also turns off
the camera.
21
The camera will turn
off to prevent
overheating.
The camera has become hot.
The camera turns off automatically. Leave the camera off
until it has cooled and then turn it on again.
75
Q (● flashes red)
Camera cannot focus.
• Refocus.
• Use focus lock.
26, 29
64
Please wait for the
camera to finish
recording.
Camera cannot perform other operations until recording
is complete.
Wait until message clears from display automatically
when recording is complete.
–
Memory card is
write protected.
Write-protect switch is in “lock” position.
Slide write-protect switch to “write” position.
–
This card cannot be
used.
Error accessing memory card.
• Use approved card.
• Check that connectors are clean.
• Confirm that memory card is correctly inserted.
19
18
18
This card cannot be
read.
Card is not
formatted. Format
card?
Yes
No
Memory card has not been formatted for use in COOLPIX
S2600.
Formatting deletes all data stored on the memory card.
Be sure to select No and make copies of any images you
wish to keep before formatting the memory card. Select
Yes and press the k button to format the memory card.
18
Out of memory.
Memory card is full.
• Choose smaller image size.
• Delete images.
• Insert new memory card.
• Remove memory card and use internal memory.
57
32
18
19