Operation Manual
Table Of Contents
- For Your Safety
- Notices
- Introduction
- First Steps
- Basic Photography and Playback: Auto Mode
- More on Shooting
- More on Playback
- Operations in Full-frame Playback Mode
- Viewing Multiple Images: Thumbnail Playback
- Taking a Closer Look: Playback Zoom
- Selecting Playback Mode
- Sorting Favorite Pictures (Favorite Pictures Mode)
- Image Searching in Auto Sort Mode
- Selecting Images Captured on a Specific Day (List by Date Mode)
- Playback Options
- Setting the Image Rating
- Enjoying Slide Show
- Protecting Important Images (Protect)
- Creating a DPOF Print Order
- Rotate Image
- Voice Memo: Recording and Playback
- Editing Images
- Movie Recording and Playback
- Connecting to Televisions, Computers and Printers
- Basic Camera Setup
- Setup Menu
- Welcome Screen
- Time Zone and Date
- Monitor Settings
- Print Date (Imprinting Date and Time)
- Vibration Reduction
- Motion Detection
- AF Assist
- Digital Zoom
- Sound Settings
- Auto Off
- Format Memory/Format Card
- Language
- TV Settings
- Charge by Computer
- Blink Warning
- Reset All
- Copy (Copy Between Internal Memory and Memory Card)
- Firmware Version
- Setup Menu
- Caring for the Camera
- Technical Notes and Index
136
Connecting to a TV
Connecting to Televisions, Computers and Printers
Operations with TV Connection
While images are displayed full-frame on the TV, the previous or next image can be
viewed by dragging your finger across the camera monitor.
• By operating the zoom control, images can be displayed as thumbnails (A 83)
and image display can be enlarged (A 85).
• When the first frame of a movie is displayed, the movie can be played back by
holding your finger on the camera monitor and removing it after about one
second.
• Tap the camera monitor to turn TV display off and display the image in the
camera monitor. When images are displayed in the camera monitor, tap the
controls displayed to operate the camera.
• Images will be automatically displayed on the TV in the following situations.
- No operations are performed for a few seconds.
- A slide show is played back.
- A movie is played back.
C Using a TV Remote Control (HDMI Device Control)
T
he remote control of an HDMI-CEC-compatible TV can be used to control playback. Image
selection, movie playback and pause, and switching between full-frame playback mode and 4-
image thumbnail display mode are available.
• Set the HDMI device control setting (A 164) of TV settings to On (default setting) and then
connect the camera and TV using an HDMI cable.
• Aim the remote control at the TV when operating it.
• Refer to the TVs operating instructions for information about the TVs HDMI-CEC compatibility.