Instruction Manual

24
Jp
En
Kr
Measurement
CAUTION: Controls, adjustments or usage of procedures other
than those specified herein may produce negative effects or damage
to your health due to laser radiation.
 Adjusting the focus of the internal display
If the internal display is difficult to see, adjust
the focus with the following procedure.
1. Press the PWR button to turn on the power.
2. Look through the eyepiece and rotate the
diopter adjustment ring until the internal
display comes into focus.
Diopter adjustment ring
 Measuring
1. Press the PWR button to turn on the power.
If you do not operate the buttons for about
8 seconds, the power turns off
automatically.
Immediately
after power-on
2. Aim at the target.
Position the center of the target mark on
the target.
Target mark
3. Press the PWR button to measure.
• Single and continuous measurements are available.
*1
• The product may vibrate for approx. 0.2 seconds (LOCKED ON
QUAKE).
*2
• After measurement, the result is displayed for approx. 8
seconds, then the power turns off automatically.
Example of measured
distance display
Example of measurement
failure
• Press the PWR button while the power is on to measure again.