Instruction Manual

Table Of Contents

Single measurement versus continuous measurement

• Single measurement: Pressing the PWR button once starts single

measurement, then displays the results. If measurement fails,

measurement continues automatically for up to about 4 seconds

until results are obtained.

• Continuous measurement: Press and hold down the PWR button to

start continuous measurement up to approx. 8 seconds. During

measurement, the measured result is displayed continuously while

the laser irradiation mark is blinking. If you release your finger from

the button, continuous measurement stops.

Standby

Continuous measurement

Press the PWR button once

Press and hold down

the PWR button

Single measurement

LOCKED ON QUAKE (first target priority detection notice function)

When measuring overlapping subjects, such as a flagstick (first target)

with trees in the background (distant target), the product vibrates to

notify you that the distance to the closest subject (first target) is

displayed.

• Single measurement: When measuring overlapping subjects and the

distance to the closest subject is displayed, the product vibrates

briefly.

• Continuous measurement: Same as single measurement. The product

also vibrates briefly when displayed figures shift to a closer subject.

ll When measuring a flagstick at a golf course

Keep targeting the flagstick at the center of the target mark with the

continuous measurement function to minimize the effects of hand shake.