Instruction Manual

Table Of Contents

Under Nikon’s measurement conditions.

This product is equivalent to JIS/IEC protection class 4 (IPX4) (under Nikon’s

testing conditions). This rating does not guarantee the water resistance

performance of the unit or that it will be free from damage or problems under

all conditions. Please observe the following when using:

• Do not operate or hold the product in running water.

• If any moisture is found on movable parts of this product, stop using the

product and wipe it off.

Battery life

Approx. 10,000 measurements (at approx. 20°C (68°F))

This figure may differ according to conditions such as temperature and other

factors. Use only as a guide.

• The battery supplied with this product is for operation checking. Due to natural

electrical discharge, the life of this battery will likely be shorter than that noted

above.

 Troubleshooting/Repair

If this product fails to function as expected, check the list below

before consulting your local dealer or the store where you purchased

it.

ll If there is a problem with the product

Does not turn on

• Press the PWR button (top of the body).

• Check that the battery is inserted correctly.

• Replace the battery with a new one.

Unable to measure / Anomalous result

• Confirm the settings.

• Confirm if it can measure a large target close to you (example: a

building approx. 15 m/yd. ahead of you).

• Clean the lens surface if necessary.

ll When requesting for repair

Please contact your local dealer or the store where you purchased the

product. Do not disassemble. It may result in a serious incident.

Please note that Nikon is not responsible for any direct or indirect

damage if the user attempts to disassemble the product.