Menu Guide
Table Of Contents
- Table of Contents
- Menu Guide
- Defaults
- The Playback Menu: Managing Images
- The Photo Shooting Menu: Shooting Options
- Photo Shooting Menu Bank
- Extended Photo Menu Banks
- Storage Folder
- File Naming
- Role Played by Card in Slot 2
- Flash Control
- Image Area
- Image Quality
- Image Size
- NEF (RAW) Recording
- ISO Sensitivity Settings
- White Balance
- Set Picture Control
- Manage Picture Control
- Color Space
- Active D-Lighting
- Long Exposure NR (Long Exposure Noise Reduction)
- High ISO NR
- Vignette Control
- Auto Distortion Control
- Auto Bracketing Set
- Multiple Exposure
- HDR (High Dynamic Range)
- Interval Timer Shooting
- Silent Live View Photography
- The Movie Shooting Menu: Movie Shooting Options
- Custom Settings: Fine-Tuning Camera Settings
- Custom Settings Bank
- a: Autofocus
- a1: AF-C Priority Selection
- a2: AF-S Priority Selection
- a3: Focus Tracking with Lock-On
- a4: 3D-Tracking Face-detection
- a5: 3D-Tracking Watch Area
- a6: Number of Focus Points
- a7: Store by Orientation
- a8: AF Activation
- a9: Limit AF-Area Mode Selection
- a10: Autofocus Mode Restrictions
- a11: Focus Point Wrap-Around
- a12: Focus Point Options
- b: Metering/Exposure
- c: Timers/AE Lock
- d: Shooting/Display
- e: Bracketing/Flash
- f: Controls
- g: Movie
- The Setup Menu: Camera Setup
- Format Memory Card
- Language
- Time Zone and Date
- Monitor Brightness
- Monitor Color Balance
- Virtual Horizon
- Information Display
- AF Fine-Tune
- Non-CPU Lens Data
- Clean Image Sensor
- Lock Mirror up for Cleaning
- Image Dust Off Ref Photo
- Image Comment
- Copyright Information
- IPTC
- Voice Memo Options
- Beep
- Touch Controls
- HDMI
- Location Data
- Wireless Remote (WR) Options
- Assign Remote (WR) Fn Button
- Network
- Slot Empty Release Lock
- Battery Info
- Save/Load Settings
- Reset All Settings
- Firmware Version
- The Retouch Menu: Creating Retouched Copies
- My Menu/Recent Settings
97
If Restart standby timer is selected, operating the multi selector
when the standby timer expires will activate the meters and start
the standby timer.
If Do nothing is selected, the timer will not start
when the multi selector is pressed.
Selecting Ye s allows adjustments that are normally made by
holding the E, S (Q), I, BKT, Y, W (M), S, T, U, or AF-
mode button and rotating a command dial to be made by rotating
the command dial after the button is released.
This also applies to
controls to which Active D-Lighting has been assigned as a “press +
command dial” option for Custom Setting f1 (Custom control
assignment, 0 89).
Setting ends when any of the affected
buttons is pressed again, the shutter-release button is pressed
halfway, or the standby timer expires.
If (W) is selected, the exposure indicators in the
top control panel and information display are displayed with
negative values on the left and positive values on the right.
Select
(V) to display positive values on the left and
negative values on the right.
Select Disable to disable the a button, preventing live view from
starting accidentally.
If Enable (standby timer active) is selected,
the a button can only be used to start live view while the standby
timer is active.
f5: Multi Selector
G button ➜ A Custom Settings menu
f6: Release Button to Use Dial
G button ➜ A Custom Settings menu
f7: Reverse Indicators
G button ➜ A Custom Settings menu
f8: Live View Button Options
G button ➜ A Custom Settings menu