Reference Manual

Table Of Contents
342
Taking Photos at a Set Interval (Interval Timer Shooting)
If shooting cannot proceed at current settings—for example, if shutter
speed is set to
A
(“Bulb”) or
%
(“Time”), [00:00'00"] is selected for
[Interval], or the start time is in less than a minute—a warning will be
displayed in the monitor.
If [Time-lapse movie] is selected for [Options], the standby timer will
not expire during interval-timer photography, regardless of the option
selected for Custom Setting c2 [Standby timer].
If the memory card is full, the interval timer will remain active but no
pictures will be taken. Insert another memory card and resume shooting
(
0
346).
Interval timer shooting will pause if:
- The camera is turned off and then on again (when the camera is off,
batteries and memory cards can be replaced without ending interval-
timer photography)
-
E
or MUP is selected for release mode
Changing camera settings while the interval timer is active may cause
shooting to end.
D
Release Mode
Regardless of the release mode selected, the camera will take the
specified number of shots at each interval.
D
Adjusting Settings Between Shots
Pictures can be viewed and shooting and menu settings adjusted
between shots. Note, however, that the monitor will turn off
approximately 2 s before the next shot is taken.