User's Manual
Table Of Contents
- Package Contents
- About This Manual
- Table of Contents
- Menu List
- For Your Safety
- Notices
- Getting to Know the Camera
- First Steps
- Basic Photography and Playback
- Camera Controls
- The MENU Button
- The i Button (the i Menu)
- The info Button
- The Focus-Mode Selector
- The AF-Mode Button
- The AF-ON Button
- The MODE Button
- The Release Mode Dial and Quick Release-Mode Selection Button
- The Metering Button
- The BKT Button
- The ISO (FORMAT) Button
- The Exposure Compensation Button
- The QUAL Button
- The WB Button
- The Protect (Picture Control/Help) Button
- The Thumbnail (Flash Mode) Button
- The Pv Button
- The Fn1, Fn2, Fn3, and Fn (Vertical) Buttons
- Troubleshooting
- Technical Notes
- Camera Displays
- Compatible F Mount Lenses
- Compatible Flash Units
- Other Compatible Accessories
- Software
- Caring for the Camera
- Caring for the Camera and Battery: Cautions
- Exposure Program
- Specifications
- Approved Memory Cards
- Memory Card Capacity
- Battery Endurance
- Location Data (GPS/GLONASS)
- Trademarks and Licenses
- Notices
- Bluetooth and Wi-Fi (Wireless LAN)
- Index
- Warranty Terms - Nikon Europe Service Warranty
219
Caring for the Camera
D
Use a Reliable Power Source
The shutter curtain is delicate and easily damaged. If the camera powers
off while the mirror is raised, the curtain will close automatically. To
prevent damage to the curtain caused by the shutter closing
inadvertently during the operation, observe the following precautions:
•
Do not turn the camera off while the mirror is raised.
•
Do not remove or disconnect the power source while the mirror is
raised.
•
If the battery runs low while the mirror is raised, a beep will sound and
the self-timer lamp will flash. The shutter curtain will close and the
mirror will be lowered after about two minutes; end cleaning or
inspection immediately.
D
Foreign Matter on the Low-Pass Filter
Foreign matter entering the camera when lenses or body caps are
removed or exchanged (or in rare circumstances lubricant or fine particles
from the camera itself) may adhere to the low-pass filter, where it may
appear in photographs taken under certain conditions. To prevent entry
of foreign matter when attaching the body cap or exchanging lenses,
avoid dusty environments and be sure to remove all dust and other
foreign matter that may be adhering to the camera mount, lens mount, or
body cap. To protect the camera when no lens is in place, be sure to
replace the supplied body cap. Should you encounter foreign matter that
cannot be removed using the image sensor cleaning option (
0
213),
clean the low-pass filter as described in “Manual Cleaning” (
0
216), or
have the filter cleaned by authorized Nikon service personnel.
Photographs affected by the presence of foreign matter on the sensor can
be retouched using the clean image options available in some imaging
applications.