User's Manual
Table Of Contents
- Get SnapBridge Now!
- Package Contents
- Table of Contents
- For Your Safety
- Notices
- Introduction
- First Steps
- Connecting Using SnapBridge
- Tutorial
- Basic Photography and Playback
- Matching Settings to the Subject or Situation (Scene Mode)
- Special Effects
- P, S, A, and M Modes
- User Settings: U1 and U2 Modes
- Release Mode
- Image Recording Options
- Focus
- ISO Sensitivity
- Exposure
- White Balance
- Image Enhancement
- Flash Photography
- Remote Control Photography
- Recording and Viewing Movies
- Other Shooting Options
- More on Playback
- Menu List
- Technical Notes
- Compatible Lenses
- Other Accessories
- Caring for the Camera
- Caring for the Camera and Battery: Cautions
- Troubleshooting
- Error Messages
- Specifications
- AF-S DX NIKKOR 18–140mm f/3.5–5.6G ED VR Lenses
- AF-S DX NIKKOR 18–200mm f/3.5–5.6G ED VR II Lenses
- Approved Memory Cards
- Memory Card Capacity
- Battery Life
- Index
- Warranty Terms - Nikon Europe Service Warranty
292
❚❚ Manual Cleaning
If foreign matter can not be removed from the image sensor
using the Clean image sensor option in the setup menu
(0 289), the sensor can be cleaned manually as described
below. Note, however, that the sensor is extremely delicate and
easily damaged. Nikon recommends that the sensor be cleaned
only by Nikon-authorized service personnel.
1 Charge the battery or connect an AC adapter.
A reliable power source is required when inspecting or
cleaning the image sensor. Turn the camera off and insert a
fully-charged battery or connect an optional AC adapter and
power connector. The Lock mirror up for cleaning option is
only available in the setup menu if the camera is not
connected to a smart device via Bluetooth and the battery
level is over J.
2 Remove the lens.
Turn the camera off and remove the lens.
3 Select Lock mirror up for cleaning.
Turn the camera on and highlight
Lock mirror up for cleaning in the
setup menu and press 2.