Menu Guide
Table Of Contents
- Table of Contents
- Menu Guide
- Defaults
- The Playback Menu: Managing Images
- The Photo Shooting Menu: Shooting Options
- Photo Shooting Menu Bank
- Extended Photo Menu Banks
- Storage Folder
- File Naming
- Primary Slot Selection
- Secondary Slot Function
- Flash Control
- Image Area
- Image Quality
- Image Size
- NEF (RAW) Recording
- ISO Sensitivity Settings
- White Balance
- Set Picture Control
- Manage Picture Control
- Color Space
- Active D-Lighting
- Long Exposure NR (Long Exposure Noise Reduction)
- High ISO NR
- Vignette Control
- Auto Distortion Control
- Flicker Reduction
- Auto Bracketing Set
- Multiple Exposure
- HDR (High Dynamic Range)
- Interval Timer Shooting
- Focus Shift Shooting
- Silent Live View Photography
- The Movie Shooting Menu: Movie Shooting Options
- Reset Movie Shooting Menu
- File Naming
- Destination
- Image Area
- Frame Size/Frame Rate
- Movie Quality
- Movie File Type
- ISO Sensitivity Settings
- White Balance
- Set Picture Control
- Manage Picture Control
- Active D-Lighting
- High ISO NR
- Flicker Reduction
- Microphone Sensitivity
- Attenuator
- Frequency Response
- Wind Noise Reduction
- Electronic VR
- Time-Lapse Movie
- Custom Settings: Fine-Tuning Camera Settings
- Custom Settings Bank
- a: Autofocus
- a1: AF-C Priority Selection
- a2: AF-S Priority Selection
- a3: Focus Tracking with Lock-On
- a4: 3D-Tracking Face-Detection
- a5: 3D-Tracking Watch Area
- a6: Number of Focus Points
- a7: Store by Orientation
- a8: AF Activation
- a9: Limit AF-Area Mode Selection
- a10: Autofocus Mode Restrictions
- a11: Focus Point Wrap-Around
- a12: Focus Point Options
- a13: Manual Focus Ring in AF Mode
- b: Metering/Exposure
- c: Timers/AE Lock
- d: Shooting/Display
- d1: CL Mode Shooting Speed
- d2: Max. Continuous Release
- d3: ISO Display
- d4: Sync. Release Mode Options
- d5: Exposure Delay Mode
- d6: Electronic Front-Curtain Shutter
- d7: File Number Sequence
- d8: Peaking Highlight Color
- d9: Viewfinder Grid Display
- d10: LCD Illumination
- d11: Live View in Continuous Mode
- d12: Optical VR
- e: Bracketing/Flash
- f: Controls
- g: Movie
- The Setup Menu: Camera Setup
- Format Memory Card
- Language
- Time Zone and Date
- Monitor Brightness
- Monitor Color Balance
- Virtual Horizon
- Information Display
- AF Fine-Tune
- Non-CPU Lens Data
- Clean Image Sensor
- Lock Mirror up for Cleaning
- Image Dust Off Ref Photo
- Image Comment
- Copyright Information
- Beep Options
- Touch Controls
- HDMI
- Location Data
- Wireless Remote (WR) Options
- Assign Remote (WR) Fn Button
- Airplane Mode
- Connect to Smart Device
- Send to Smart Device (Auto)
- Wi-Fi
- Bluetooth
- Network
- Eye-Fi Upload
- Conformity Marking
- MB-D18 Battery Type
- Battery Order
- Battery Info
- Slot Empty Release Lock
- Save/Load Settings
- Reset All Settings
- Firmware Version
- The Retouch Menu: Creating Retouched Copies
- My Menu/Recent Settings
- Optional Flash Units
- Technical Notes
231Optional Flash Units
3 C: Choose a channel.
Set the WR-R10 channel selector to
the desired channel.
4 C: Choose a link mode.
Select Wireless remote (WR)
options> Link mode in the setup
menu (0 180) and choose from the
following options:
• Pairing: The camera connects only to
devices with which it has previously
been paired, preventing signal interference from other
devices in the vicinity. Given that each device must be
paired separately, PIN is recommended when connecting
to a large number of devices.
• PIN: Communication is shared among all devices with the
same four-digit PIN, making this a good choice for
photography featuring a large number of remote devices. If
there are multiple cameras present that share the same PIN,
the flash units will be under the sole control of the camera
that connects first, preventing all other cameras from
connecting (the LEDs on the WR-R10 units connected to the
affected cameras will blink).