User's Manual

188
3 Adjust flash settings.
Choose the flash mode (0 192) and flash control mode
(0 190).
4 Adjust shutter speed and aperture.
5 Take pictures.
D Third-Party Flash Units
The camera cannot be used with flash units that would apply voltages
over 250 V to the camera’s X contacts or short-circuit contacts on the
accessory shoe. Use of such flash units could not only interfere with
normal operation of the camera but also damage the flash sync circuits
of the camera and/or flash.
A Shutter Speed
Shutter speed can be set as follows when an optional flash unit is used:
Mode Shutter speed
P, A Set automatically by camera (
1
/ 250 s–
1
/ 60 s)
*
S Value selected by user (
1
/ 250 s–30 s)
M Value selected by user (
1
/ 250 s–30 s, Bulb (A), Time (%))
* Shutter speed may be set as slow as 30 s if slow sync, slow rear-curtain sync, or slow sync
with red-eye reduction is selected for flash mode.
A The Sync Terminal
A sync cable can be connected to the sync
terminal as required. Do not connect
another flash unit via a sync cable when
performing rear-curtain sync flash
photography with a flash unit mounted on
the camera accessory shoe.