User manual

152
Z
❚❚ Canceling Bracketing
To cancel bracketing, press the D button and rotate the main
command dial until the number of shots in the bracketing
sequence is zero (r) and d is no longer displayed.
The
program last in effect will be restored the next time bracketing is
activated.
Bracketing can also be cancelled by performing a two-
button reset (0 207), although in this case the bracketing
program will not be restored the next time bracketing is activated.
A ADL Bracketing
In continuous low speed and continuous high speed modes, shooting
will pause after the number of shots specified in the bracketing
program have been taken.
Shooting will resume the next time the
shutter-release button is pressed.
If 1 is selected for Custom Setting c3
(Self-timer) > Number of shots (0 317) in self-timer mode, the camera
will take one shot each time the shutter-release button is pressed, but if
the Number of shots is 2 or more, the camera will take all the shots in
the sequence in a single burst at the interval selected for Custom
Setting c3 (Self-timer) > Interval between shots.
In other modes, one
shot will be taken each time the shutter-release button is pressed.
If the memory card fills before all shots in the sequence have been
taken, shooting can be resumed from the next shot in the sequence
after the memory card has been replaced or shots have been deleted to
make room on the memory card. If the camera is turned off before all
shots in the sequence have been taken, bracketing will resume from the
next shot in the sequence when the camera is turned on.