Product Manual
Table Of Contents
- Nikon N Series/K Series Total Station Instruction Manual
- Legal Notices
- Safety
- Introduction
- Preparation
- Unpacking and Packing the Instrument
- Charging the Battery Pack
- Detaching and Re-Attaching the Battery Pack
- Setting Up the Tripod
- Centering
- Leveling
- Sighting
- Setting the Measurement Mode and Preparing the Target
- Measurement in Reflectorless Mode (N 2" and N 5" only)
- Setting Up the Prism Reflector
- Face-1/Face-2 Measurement
- External Device Connector
- Getting Started
- Applications
- HA Reset and Angle Operations
- Station Setup
- Setting up a station with known coordinates or azimuth
- Setting up a station using multiple point resection
- Setting up the station quickly without coordinates
- Determining station elevation
- Checking and resetting the backsight direction
- Base XYZ function
- Two-point resection along a known line
- Setting up a station for traverse measurement
- Use last
- Stakeout
- Program Key
- Recording Measurement Data
- Measuring Offsets
- Menu Key
- Checking and Adjustment
- System Diagrams
- Communications
- Error Messages
5 Menu Key
100 Nikon N Series/K Series Total Station Instruction Manual
To move between fields, press [^] or [v]. Alternatively, to move to the next field, press
[ENT].
To change the setting in the selected field, press
[<] or [>].
To confirm the job settings and create the job, press
[ENT] in the last field (HA).
These settings are separate from other temporary settings.
Deleting a job
B
Tip – There is no undelete function in the Job Manager. Before you press [ENT] or select DEL,
make sure that the selected job is the one that you want to delete.
1. In the job list, highlight the job that you want to
delete.
2. Press the
DEL softkey. A confirmation screen
appears.
3. Do one of the following:
– To delete the selected job, press [ENT] or the
DEL softkey.
– To cancel the deletion and return to the previous screen, press [ESC] or the
Abrt softkey.
After you delete a job, the display returns to the
job list.
Setting the control job
If you search for a point when a control job is specified, and the system cannot find
the point in the current job, the control job is also searched. If the point is found in the
control job, it is copied to the current job as a UP record.
A control job has the same format as a standard job. You can open and modify it like
any other job, and you can use it to record any measured data.
To set the control job:
1. Highlight the job that you want to use.
2. Press the
Ctrl softkey.